Welcome to my blog

Got a working shifter setup installed in the car today. Since the front wheel drive setup had a shift rod running straight out the back it was not that hard to bend a section of pipe to go around the frame and run it forward…

I managed to get the CV axles made up and installed today. I ended up using two axles on one side. I just stuck them both in one in the engine and one in the wheel then marked them in the center to know where…

Didn’t get a lot of time to work on it today but I at least managed to finish mounting the fuel pump and get it wired up and everything on it working properly.  With the tank assembled I figured I might as well check the…

The steering parts came in today so I put it all together. The stock rack was not long enough so I put a set of rack extenders on it to make it the proper angle so there is no bump steer. The front end is…